Over the past few weeks, I’ve been working to migrate the site to a free cloud compute occasion to ensure that Woodschick and Dirtdame no longer really have to fund it.

The following link is viewable in PDF structure . Please allow a number of moments to obtain for your Pc

I'm going to put up A further pic tomorrow to point out much more depth as it's bent on either side - ideal to accomplish each at exact same time?

Difficult to notify from the images, but can you put your hand between the fender & the loop? If you're able to

In the last number of months, I’ve been Doing the job to migrate the website to your no cost cloud compute occasion so that Woodschick and Dirtdame no longer must fund it.

I do think the previous post was greater. Doing every one of the do the job you have done around the bicycle, the shocks will probably be a "enjoyable" undertaking. But however I trip like my ten calendar year previous daughter so who is aware of if I did them right!

Abide by along with the video under to determine how to setup our site as a web application on your own home display. Take note: This feature might not be accessible in some browsers.

It costed me 250 € for your components. It's not at all straightforward to locate the ideal range for your sections due to the fact here various quantities are doable. Far better to cell phone into the importer to acquire enable.

Over the past handful of weeks, I’ve been Doing the job to migrate the site to a no cost cloud compute occasion making sure that Woodschick and Dirtdame no more have to fund it.

Good obtain, In advance of i Slice off the rear loop, i'd line up a website welder, be certain he/she will be able to weld it back again adequately.

Exam rode a Awp four hundred WR way back again when. Wasn't the bike for me at the time. But its normally lurked behind my head.

Terrific handling. Do what Crash explained. I've straightened many Awp rear frame loops bent like more info yours over the past 24 years with heat and just pulling down until straight. Just go slow so you don't kink the tubing.

Did the legalization for Germany and did a primary vintage enduro race very last weekend. I love the bicycle, but:

Your entire hoop tubing get more info actually extends very well ahead as A part of the complete bicycle frame so somewhat not Lower/remake. Having said that, I could see slicing the hoop's Heart weld, if that would make straightening less difficult......Or get more info perhaps soften and bend The 2 aspect bends to start with, then afterwards attempt to straighten the bend at center weld. Anyone Consider just one plan much better than other?